Carcass and meat quality traits of four different pig crosses

The study compared properties of Finnish Landrace × Yorkshire crossbred sows mated with Finnish Landrace (FL), Norwegian Landrace (NL), Norwegian Duroc × Norwegian Landrace (NDL), or Swedish Hampshire (SH) boars. The focus was to study the cross-sectional area of loin, cross-sectional area and number of muscle fibres, loin colour and pH value as well as the ratio of water to protein in the loin.The four studied crosses were quite similar having only small differences in carcass and meat quality. The carcass lean content was the lowest in NDL. The loins of FL and NL were longer than the loins of NDL and of SH. The cross-sectional area of loin was the largest in SH. The loin of FL was lighter in colour and the loin of SH was redder than the loins of the other crosses studied. The protein content was lower and the ratio of water to protein higher in loin of SH than in the other crosses.     

Oxidation of 4-chloro-3-methylphenol in pressurized hot water/supercritical water with potassium persulfate as oxidant

4-Chloro-3-methylphenol (c = 2.0 mM), representing a model pollutant, was oxidized in pressurized hot water and in supercritical water in a continuous flow system. Potassium persulfate was used as oxidant in concentrations of 8.0 and 40.0 mM. Contact times (reaction times) were 3-59 s, temperatures 110-390 degrees C, and pressures 235-310 bar. A wide temperature range was tested to determine the range over which potassium persulfate can be used effectively. Good oxidation efficiencies for 4-chloro-3-methylphenol were obtained at both oxidant concentrations and with short contact times at temperatures clearly underthe critical temperature of water; total organic carbon content of the effluent was low under optimized conditions. Corrosion, measured as nickel and chromium concentrations of the effluent, was more severe at oxidant concentration of 40.0 mM. Sulfate was present in the effluent in high concentrations. Sulfate is the limiting factor in the use of potassium persulfate in wastewater treatment and requires further water treatment.     

Nitrate reductase activity in some subarctic species and UV influence in the foliage of Betula pendula Roth. seedlings

Nitrate reductase (NR) activity was studied in the foliage of five subarctic species: mature trees of European white birch (Betula pubescens Erch. S.S.), Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies L. Karst), Ericaceous shrub bilberry (Vaccinium myrtillus L.), naturally growing in a forest, and seed-grown silver birch (Betula pendula Roth.) seedlings in an ultraviolet (UV) exclusion field experiment at the Pallas-Ounastunturi National Park in Finnish Lapland (68 degrees N). Mean NR activity ranged from 0 in bilberry to 1477 (S.D. = 277.7) and 1910 (S.D. = 785.4) nmol g(-1) DW h(-1) in mature trees of European white birch and silver birch seedlings, respectively. Significant differences due to UV exclosure treatments were determined for the NR activity of silver birch seedlings (F = 3.62, P= 0.025*) after three growing seasons (191 days) of UV exclusion. The ambient and control silver birch seedlings had or tended to have higher NR activity than those grown under UV exclusion. No relationship was found between the foliage NR activity and total nitrogen content, which ranged from 0.61 to 1.35% per seedling. The present study suggests large differences in NR activity between the species and the induction of NR activity in silver birch seedlings due to ambient UV radiation.     

Human low-density lipoprotein-coated capillaries in electrochromatography

Low-density lipoprotein (LDL) particles were immobilized on the inner wall of a fused-silica capillary and used in a study of the interactions between LDL and neutral drugs in electrochromatography. The effect of coating parameters (pH, ionic strength of the coating solution, duration of the coating procedure) on the properties and stability of the coating was examined. The stability of the coating was highest when the pH of the coating solution was under the pI value of the LDL particles. Interactions of unmodified LDL coatings with drugs were compared with those of acetylated LDL coatings. Acetylation of LDL neutralizes the positive charge on the lysine residues of the protein component of LDL particles, and acetylated LDL was used as a reference to examine the effect of the positively charged amino acids in the unmodified coating. Under similar coating conditions, acetylated LDL coating yielded stronger EOF evidently due to the decreased number of positive charges on LDL particles. The interactions of the unmodified and acetylated LDL coatings with steroids aldosterone, testosterone, and progesterone were comparable, which indicates that the density of immobilized LDL particles is not appreciably altered by acetylation. As expected, the strength of the interactions between steroids and the LDL coating increased with hydrophobicity of the drug.     

A new heart rate variability-based method for the estimation of oxygen consumption without individual laboratory calibration: application example on postal workers

Traditionally, the estimation of oxygen consumption (VO2) at work using heart rate (HR) has required the determination of individual HR/VO2 calibration curves in a separate exercise test in a laboratory (VO2-TRAD). Recently, a new neural network-, and heart rate variability-based method has been developed (Firstbeat PRO heartbeat analysis software) for the estimation of VO2 without individual calibration (VO2-HRV). In the present study, the VO2-values by the VO2-HRV were compared with the values by VO2-TRAD in 22 postal workers. Within individuals the correlation between the two methods was high (range 0.80-0.99). The VO2-TRAD gave higher values of VO2 compared to VO2-HRV (19%) especially during low physical activity work when non-metabolic factors may increase HR. When assessed in different HR categories, the smallest difference (11%), and highest correlations (range 0.83-0.99) in VO2 between the methods were observed at higher HR levels. The results indicate that the VO2-HRV is a potentially useful method to estimate VO2 in the field without laboratory calibration.     

Pressurized hot water extraction coupled on-line with LC-GC: determination of polyaromatic hydrocarbons in sediment

Pressurized hot water extraction (PHWE) was directly combined with a LC-GC system for the determination of polyaromatic hydrocarbons (PAHs) in sediment. The sediment sample was first extracted with pressurized hot water, and the analytes were adsorbed into a solid-phase trap. The trap also functioned as a LC column, which removed most of the interfering matrix components. The 780-microL LC fraction containing the analytes was directly transferred to the GC using an on-column interface. The whole PHWE-LC-GC analysis took place in a closed system, and no sample pretreatment was required. The sensitivity of the method was excellent due to the efficient concentration in the LC-GC system. Sensitivity was approximately 800 times better than in traditional systems. In addition, only a small amount of sample (10 mg) was required for the analysis. The PHWE-LC-GC method proved to be linear in the concentration range of 0.01-2 microg/g, the limits of quantification were below 0.01 microg/g for all the analytes, and the relative standard deviations were between 3 and 28%. LC cleanup and the improved sensitivity made detection with FID sufficient for the determination of analytes. The results were comparable to those obtained in an interlaboratory comparison study as well as to the results obtained with off-line SFE-GC-MS.     

Extractability of metals and ecotoxicity of soils from two old wood impregnation sites in Finland

Four metal-contaminated soil samples were classified using physical methods, extracted by selective extraction procedures and analyzed for chemical concentrations. De-ionized water, 0.01 mol/l barium chloride, 1 mol/l ammonium acetate and concentrated nitric acid were used as extraction solutions. Ecotoxicity of water extracts and soil samples was analyzed in order to describe the bioavailability of the contaminants. Samples from old wood impregnation plants contained high amounts of As, Cu, Cr and Zn, which originated from chromated copper arsenate, ammoniacal copper-zinc arsenate, and ammoniacal copper quaternary compound. Total As concentrations of the heavily contaminated samples varied from 752 to 4340 mg/kg, Cu concentrations from 339 to 2330 mg/kg, Cr concentrations from 367 to 2,140 mg/kg and Zn concentrations from 79 to 966 mg/kg. The extractabilities of metals differed according to soil type, extractant and element. Cu and Zn were proposed to cause the highest toxicity in the water extracts of the soils. Ecotoxicity tests displayed rather high differences in sensitivity both for water extracts and for solid soil samples. Reproduction of Enchytraeus sp. was the most sensitive and seed germination of Lactuca sativa the least sensitive and the other tests were in decreasing order of sensitivity: Folsomia candida>reverse electron transport>MetPLATE>Toxichromotest>Allium cepa root growth>Lemna sp. growth. As a conclusion, polluted soils rich in sand retain heavy metals with less firm bindings, particularly in the case of Cu and Zn, than soils rich in clay, indicating that chemical methods for measuring the bioavailability of metals need to be optimized taking into account the soil type, acidity, redox state and the individual contaminants.     

High level of antimicrobial resistance in Campylobacter jejuni isolated from broiler chickens in Estonia in 2005 and 2006

The development of antimicrobial resistance in Campylobacter jejuni and Campylobacter coli is a matter of increasing concern. Because campylobacteriosis is transmitted to humans usually via food of animal origin, the presence of antimicrobial-resistant campylobacters in broiler chickens has important public health implications. The aim of our study was to analyze resistance patterns of C. jejuni isolated from fecal samples collected at a large Estonian chicken farm, from cecal contents collected at slaughterhouses, and from meat samples collected at the retail establishments in 2005 and 2006. A total of 131 C. jejuni isolates were collected over a 13-month period and tested by the broth microdilution VetMIC method (National Veterinary Institute, Uppsala, Sweden) to determine the MICs of various antimicrobials. Resistance to one or more antimicrobials was detected in 104 (79.4%) of the 131 isolates. High proportions of the isolates were resistant to enrofloxacin (73.3%) and nalidixic acid (75.6%). Multidrug resistance (resistance to three or more unrelated antimicrobials) was detected in 36 isolates (27.5%), all of which were resistant to enrofloxacin. Multidrug resistance was significantly associated with enrofloxacin resistance (P < 0.01), and the use of enrofloxacin may select for multiresistant strains.     

Optimization of selectivity and resolution in micellar electrokinetic capillary chromatography with a mixed micellar system of sodium dodecyl sulfate and sodium cholate

Selectivity and resolution were studied for the separation of seven corticosteroids by micellar electrokinetic capillary chromatography (MEKC) using a mixed micellar solution of sodium dodecyl sulfate (SDS) and sodium cholate (SC), buffered with 3-(N-morpholino)propanesulfonic acid (MOPS) or 3-[(1,1-dimethyl-2-hydroxyethyl)amino]-2-hydroxypropane sulfonic acid (AMPSO). The changes in selectivity were compared for the AMPSO-SDS-SC system by varying the pH and the concentrations of AMPSO, SDS and SC. The experimental design started with the central composite design and continued in a sequential manner. The optimum selectivity for the separation of the corticosteroids was calculated from the analyte migration times and the analyte velocities, by using empirical quadratic regression models. Satisfactory regression fits and coefficients of determination for prediction were obtained with cross-validated models. To optimize the resolution, the physical parameters of capillary length and analysis time were varied under the conditions optimal for the selectivity. In both the selectivity and the resolution, optimization the overall optimum was determined by using the desirability function technique. Analysis times were controlled by using 1,3-diaminopropane to influence the electroosmotic flow velocity (veo). The voltage was kept constant, which resulted in higher electric field strength in shorter capillaries. No changes in the selectivity were observed when 1,3-diaminopropane was used to control the electroosmotic flow velocity. Such an optimization technique, where the chemical and physical factors affecting the separation are treated independently, seemed to be effective for finding the best possible resolution for the corticosteroids.     

Determination of association constants of dansyl-amino acids and beta-cyclodextrin in N-methylformamide by capillary electrophoresis

The use of nonaqueous background electrolytes in capillary electrophoresis (CE) is a promising new trend which should widen the scope of this technique. We demonstrate the chiral separation of dansyl-amino acids (Dns-AAs) in N-methylformamide (NMF) using beta-cyclodextrin (beta-CD) as chiral selector. The solubility of beta-CD is much better in NMF than in water, allowing high concentration of the chiral selector and successful enantioseparation despite the weak host-guest interaction between the Dns-AAs and beta-CD. The association constants for the complexation between Dns-AAs and beta-CD could be calculated from the electrophoretic mobilities, with attention paid to the change in viscosity of the electrolyte upon addition of beta-CD. The association constants ranged between 2 and 13 M(-1).